Husqvarna 323P4 Manuel d'utilisateur télécharger pdf (Page 25)

English – 25

MAINTENANCE

On mufﬂers without a catalytic converter the mesh should be

cleaned weekly, or replaced if necessary. On mufﬂers ﬁtted

with a catalytic converter the mesh should be checked, and if

necessary cleaned, monthly. If the mesh is damaged it

should be replaced.

If the mesh is frequently blocked, this can be a sign that the

performance of the catalytic converter is impaired. Contact

your dealer to inspect the mufﬂer. A blocked mesh will cause

the machine to overheat and result in damage to the cylinder

and piston. See also instructions under the heading

Maintenance.

CAUTION! Never use a machine with a defective mufﬂer.

Cooling system

To keep the working temperature as low as possible the

machine is equipped with a cooling system.

The cooling system consists of:

1 Air intake on the starter.

2 Fins on the ﬂywheel.

3 Cooling ﬁns on the cylinder.

4 Cylinder cover (directs cold air over the cylinder).

Clean the cooling system with a brush once a week, more

often in demanding conditions. A dirty or blocked cooling

system results in the machine overheating which causes

damage to the piston and cylinder.

Spark plug

The spark plug condition is inﬂuenced by:

• Incorrect carburetor adjustment.

• An incorrect fuel mixture (too much or incorrect type of

oil).

• A dirty air ﬁlter.

These factors cause deposits on the spark plug electrodes,

which may result in operating problems and starting

difﬁculties.

If the machine is low on power, difﬁcult to start or runs poorly

at idle speed: always check the spark plug ﬁrst before taking

any further action. If the spark plug is dirty, clean it and check

that the electrode gap is 0.5 mm (0,020"). The spark plug

should be replaced after about a month in operation or earlier

if necessary.

CAUTION! Always use the recommended spark plug type!

Use of the wrong spark plug can damage the piston/cylinder.

Check that the spark plug is ﬁtted with a suppressor.

Air ﬁlter

The air ﬁlter must be regularly cleaned to remove dust and dirt

in order to avoid:

• Carburettor malfunctions

• Starting problems

• Loss of engine power

• Unnecessary wear to engine parts

• Excessive fuel consumption.

Clean the ﬁlter every 25 hours, or more regularly if conditions

are exceptionally dusty.

WARNING! Mufﬂers ﬁtted with catalytic

converters get very hot during use and

remain so for some time after stopping. This

also applies at idle speed. Contact can result

in burns to the skin. Remember the risk of

ﬁre!

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

Commentaires sur ces manuels

Pas de commentaire

Husqvarna 323P4 Manuel d'utilisateur Page 25

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Husqvarna 323P4