Husqvarna 268K Manuel d'utilisateur télécharger pdf (Page 16)

16 – English

MAINTENANCE

!

WARNING! Never use a power cutter without

a disc guard over the cutting disc.

Changing the drive belt

• Loosen the two nuts (A).

• Turn the tensioning screws

(B) until the tension has

been released.

• Remove the two nuts (A).

• Remove the front belt cover

(C).

• Remove the belt from the

pulley.

• Dismantle the cutting head.

• Remove the two nuts (D),

and the screws that are

straight under these (E) and

lift off the cutting arm.

• Replace the drive belt.

• To assemble reverse the

procedure for dismantling.

• Check the cutting disc’s

disc guard for signs of

cracking or other damage.

Replace it if damaged.

B

E

D

B

C

B

A

A

Adjusting the drive belt

• The drive belt is fully

enclosed and well protected

from dust, dirt and

mechanical effects during

the cutting process.

• To tension the drive belt,

slightly loosen the nuts (A),

which secure the cutting

head and belt guard.

• Turn the tensioning screw

so that the nut (B) is located

directly under the arrow on

the cover. Shake the head

to ensure the spring can

tension the belt. The belt

now automatically has the

right tension.

• Tighten the nuts that hold

the cutting head.

IMPORTANT INFORMATION! A new drive belt should be

tensioned after using one or two tanks of fuel.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire